Needed Tools :

• 1 Round Plier 
• 1 cutter plier 
• Earpost with eye 2 pcs..
• Wire ø  0,5mm
• Little pendants 2 Stck.
• 2 beads
• 4 spacers

Picture 2

You take any kind of bead, move it on the wire, than you push the both spacers on the wire, one spacer to the left, the other to the right side of the bead.

Picture 3

Now you have to bend the wire opposite in 90 Grade.

Picture 4

Now you bend the wire at the centre first half, then take the wire by the round plier and bend a half eye, but do not close the eye jet.

Picture5

The first pendant can be hang on the open eye now. With the top of the plier you take the wire now, close the eye and move the wire a little bit inside the bead, for making the eye stable. It is a little bit difficult and you may need some practices. If the wire seems to be to long cut it.

Picture 6

You have to repeat all steps on the other side of the earring pendant. Now you take an earhook with eye or like in this case an earpost with eye. You open the eye of the earpost and hang on the earring pendant and close the eye again.

The final picture

The finished work should look like this. Now you do all the steps again for the second earring pendant and you will have a pair of nice earring jewelry.